Web Operation And Configuration; Pc Configuration; Displaying The 3224 Web Administration Pages - Patton electronics Diamond Edge 3224 Installation Manual

G.shdsl ipdslam

Table of Contents

3 • Configuring the IpDSLAM for operation

Web operation and conﬁguration

Now that the IP address has been conﬁgured for your application, you can complete the conﬁguration using

any standard web browser.

PC conﬁguration

Note

This completes the initial conﬁguration of the Model 3224. The next steps in conﬁguration will be done using

your web browser connected via Ethernet to the Model 3224. Consult the Model 3224 Administrator Reference

Guide and Model 3224 Applications Reference Guide for conﬁguration information.

Do the following:

1. Connect your PC's Ethernet connection to the Ethernet LAN.

2. Connect the 3224's rear panel Ethernet port A to the Ethernet LAN.

3. At your PC, open a web browser session. In your browser's URL/address ﬁeld type the IP address of the

Model 3224 (for example, if the Model 3224's IP address is 123.124.221.10, you would type

123.124.221.10 in the browser's URL/address ﬁeld).

4. A login prompt will appear. In the username ﬁeld type superuser, then press <tab> to move the cursor to

the Password ﬁeld. In the Password ﬁeld type superuser, then press <enter>.

To connect the PC to the Ethernet LAN to communicate with the

Model 3224, the PC's IP address should be on the same subnet as the

3224 Ethernet 0 interface.

Connect a straight-through Ethernet cable between the PC's NIC or

PCMCIA Ethernet card and an Ethernet hub or switch.

Model 3224 G.SHDSL IpDSLAM Installation Guide

Web operation and configuration

Table of Contents