Table of Contents
Advertisement
2.1 Running the power cable through the gland
To run the power cable through the gland:
1.
Locate the gland that the power cable should be run through.
2.
You may unscrew the gland to allow more flexibility when threading the power cable wires. To unscrew
the gland, either by hand or with a Crescent® (adjustable) wrench, turn the gland to the left until it is
loosened.
Carefully thread the wires through the gland from the outside into the EnviroNET.
3.
The brass glands on the bottom panel of the EnviroNET can properly seal cables with an outer diameter
Note
between 3mm and 8mm.
2.2 Connecting the power cable wires to the EnviroNET
To connect the power cable wires to the EnviroNET:
Run the power cable wires from outside of the EnviroNET through the unscrewed gland (on the far left) to
1.
the inside of the unit.
Connect the power cable wires to the external power connection block that is labeled, E N L, as described
2.
in
table
1.
Be sure to leave a little slack on the wires so that they are not stressed or pulled too tightly. Also, make
3.
sure that the power cable wires are secured tightly in the E N L block.
To ensure that the cables are properly secured in the gland, tighten the gland by turning the loose pieces
4.
all the way to the right using a Crescent® (adjustable) wrench.
EnviroNET Quick Start Guide
2.0 Wiring the power
Table 1.
Designated Slot
Earth (E)
Neutral (N)
Line (L)
E
N
Power cable wires
Power Wire (Color)
Green
White
Black
L
3
Advertisement
Table of Contents
