Patton electronics 6081RC EdgeRoute Application Manual page 31

Models 3224 G.SHDSL IpDSLAM & 6081RC NAS Applications Guide
– The First Port button displays the configuration for the first port in the
page listing of channels (see
– The Previous Port button displays the configuration for the port previous to the one currently displayed
– The Next Port button displays the configuration for the port following the one currently displayed
– The Last Port button displays the configuration for the last port in the
page listing of channels (see
– The Reset button cancels changes made to a port configuration.
– The Submit button saves changes made to a port configuration.
3. Under the heading
Mode menu:
– BCP (bridge control protocol)
– IPCP (Internet protocol control protocol)
Note
4. Click on the Enable button below the
5. Click on the Passive checkbox if you want the particular PPP channel to wait for the remote PPP device
linked to this channel to initiate PPP channel negotiation. If box is unchecked, this PPP channel will ini-
tiate negotiation to establish a PPP session with remote device. Normally this box should be checked.
BCP Options
6. Under
select Bridge 1) and check the
PPP channel configuration
figure 24).
figure 24)
Figure 25. PPP Options page
PPP Options
, select one of the following network-control protocols (NCP) from the
Since this section is about configuring for bridged PPP, you would
select the BCP option.
Mode
, select the bridge group that the PPP channel will be attached to (for this example
Bridged
box located just above the drop-down menu.
menu to enable the NCP.
3 • Bridged data application
H.110 Channel Configuration
H.110 Channel Configuration
29