Patton electronics 6081RC EdgeRoute Application Manual page 16

2 • Physical layer configuration
– The Previous Channel button displays the configuration for the channel previous to the one
currently displayed
– The Next Channel button displays the configuration for the channel following the one
currently displayed
– The Last Channel button displays the configuration for the last channel in the H110 Channel Configu-
ration page listing of channel (see
– The Reset button cancels changes made to a channel configuration.
– The Submit button saves changes made to a channel configuration.
Enter configuration parameters for a channel as follows:
1. Enter a port number (H.110 bus port numbers range from 1 to 32) in the
Starting Timeslot
2. Enter the
will be used, enter 1 in this text box).
3. Enter the length of the channel in number of timeslots (for example, if the range of timeslots is from 1–16,
enter 16 timeslots in this text box).
4. Select to H.110 from the
direction of transmission "to H.110" or "from H.110".
5. Click the Add Map button to enter the H.110 map. This will be the map that will connect port 1 in the
6081RC to the "From H.110" direction.
Port
6. Enter 1 in the
Note
Starting Timeslot
7. Enter the
8. Enter the length in number of timeslots in the
9. Select To H.110 from the
10. Click the Add Map button to save changes.
14
Models 3224 G.SHDSL IpDSLAM & 6081RC NAS Applications Guide
Figure 9. Channel timeslot mapping page
figure 9
—each H.110 port can handle up to 128 slots (for example, if timeslots 1–16
Direction
pop-up menu. Each link in the H.110 bus should be duplex, define the
text box (port 1).
Any other available port (from 1-32) could be selected as long as it
matches a 3096RC port.
—for example if using timeslots 17–32, enters 17 in this text box).
Direction
pop-up menu.
on page 14).
Length
text box.
Configuring Model 6081RC H.110 parameters
Port
text box.