TP-Link TL-SL2210WEB User Manual page 10

Gigabit Uplink Web Smart Switch
Introduction
03
RESET
Press this button for three seconds to reset the software setting back to factory
default setting.
LEDs
LED Status
On
Power
Off
On
System
Off
On
Flashing
Link/Act
Off
On
Off
100Mbps
On
1000Mbps
Off
Port Feature
Model 10/100Mbps RJ45 Port
TL-SL2210WEB
TL-SL2218WEB
TL-SL2428WEB
TL-SL2452WEB
10/100Mbps RJ45 Port
Designed to connect to the device with the bandwidth of 10Mbps or 100Mbps. Each
port has a corresponding Link/Act and 100Mbps LED.
10/100/1000Mbps RJ45 Port
Designed to connect to the device with the bandwidth of 10Mbps, 100Mbps or
1000Mbps. It has a corresponding Link/Act and 1000Mbps LED.
SFP Port
Designed to install SFP module. It has a corresponding Link/Act LED.
Indication
The Switch is powered on
The Switch is powered off or power supply is abnormal
The Switch works properly
The Switch works improperly
A valid link is established on the port
Data is being transmitted or received. (SFP port has Link/
Act LED only and must connect to 1000Mbps device.1
No device is connected to the corresponding port
The corresponding port is running at 100Mbps
There is no device linked to the corresponding port or the
port is running at 10Mbps
The corresponding port is running at 1000Mbps
There is no device linked to the corresponding port or the
port is running at 100Mbps
10/100/1000Mbps RJ45 Port
8
16
24
48
SFP Port
1 1
1 1
2 2
2 2