Dodge 3500 Ram Chassis Cab vehicle Operations & Installation Manual page 3

2011 chassis cab

increase or decrease the engine idle speed, to optimize the PTO function, the "accel" and

"decel" cruise switches can be used respectively.

To disengage PTO operation and return to "standard vehicle operation" simply turn the

up fitter provided on/off switch to the off position.

To operate the PTO via a remote switch the customer must make sure the above

conditions are met. It is vital for proper operation that the PTO and remote have been

installed correctly paying special attention to ensure the vehicle provided wiring has been

connected properly. This is the responsibility of the installer of the PTO and

switches/remote system. It is the responsibility of the PTO manufacturer to ensure that

their electrical (switches and remote) system is compatible with the vehicle's electrical

architecture and software functionality.

Mobile Mode

This feature is activated by a switch (close to ground) in the cab after selected by a

service tool. When active, this feature limits engine speed and road speed to calibrated

values.

When this feature is selected stationary PTO and Remote PTO features (the idle increase

features in PTO mode) are not available.

To operate the PTO in this mode the vehicle must meet the following conditions:

• Dealer selected "mobile" mode activated via Dealer proprietary service tool

• Upfitter provider (on/off) switch has been activated

• Vehicle must be in "park " or "drive" position (vehicles equipped with automatic

transmission)

• Parking brake must not be applied

• No vehicle, brake or clutch switch faults present

• Vehicle must be running

• PTO must be correctly installed using the vehicle provided circuits

The customer may choose to use the PTO while the vehicle is moving. To do so the PTO

function must be activated prior to taking the vehicle out of "park". This is accomplished

by activating the up fitter provided PTO on/off switch. At this point the customer may

place the vehicle in a forward , reverse gear, or neutral and have PTO operation.

To disengage PTO operation and return to "standard vehicle operation" simply turn the

up fitter provided on/off switch to the off position.

2011 Chassis Cab

PTO Operation & Installation Guide

01/22/2010

- - - -

+ + + +

ALL

OUT