Operation - Dimplex DFG2562 Owner's Manual

Operation

Figure 6
A. Three Position Switch
The switch has two on positions
marked " I " and " II ".
The " I " position is for manual
operation. In this position the
built-in remote control is by-
passed.
The " II " position is for operating
the unit with the provided remote
control. When in the remote
control (" II ") position the unit is
operated with the ON and OFF
buttons of the remote control.
When the switch is in the center
" O " position the unit is off.
B. Heater On/Off Switch
The heater on/off switch
b
C
A
supplies power to the heater fan
and the heater element. When the
switch is in the on position, the
heater operates if the thermostat
calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your
individual requirements, turn the
thermostat control clockwise all
the way to turn on the heater.
When the room reaches the
desired temperature, turn
the thermostat knob counter-
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
Three Position on/off switch to
off and waiting five (5) minutes
before switching the unit back on.
11