Volvo V70 Owner's Manual page 257

06 Maintenance and service
Wheels and tyres
4. (For cars with steel rims.) Prize off the
wheel cover with the end of the wheel
wrench, or pull it off by hand.
5. Loosen the wheel nuts ½–1 turn anticlock-
wise with the wheel wrench.
WARNING
06
Never position anything between the
ground and the jack, nor between the jack-
ing point and the jack.
6. There are two jacking points on each side
of the car. There is a recess in the plastic
cover at each point. Crank the foot of the
jack down so it is pressed squarely on the
ground.
*
256
Option/accessory, for more information, see Introduction.
7. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
Installation
1. Clean the contact surfaces on wheels,
hubs and brake discs.
2. Put on the wheel. Screw in the wheel bolts.
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tight-
ened properly. Tighten to 140 Nm. Check
the torque with a torque wrench.
5. Fit on the wheel cover (for cars with steel
rims).
NOTE
The hubcap outlet for the valve must be
located over the valve on the rim when fit-
ted.
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack.
Park the car so that passengers have the car
- or preferably a crash barrier - between
them and the road.
Emergency puncture repair*