Step 4: Adding Cameras - Visonic PowerLink User Manual

4. Click Apply to save your changes.

Step 4: Adding Cameras

If you have cameras connected to the Visonic PowerLink you need to configure the
cameras. This enables viewing the image on a remote computer
1. In the left frame of the Visonic PowerLink window click SETUP.
2. Click the CAMERAS tab.
To add a camera to the Visonic PowerLink:
Note
Wired and Wireless cameras, when added, must be connected to the Router one by one.
Please refer to the specifications page for a list of supported cameras
1. Connect the camera to the Home Router (or to an Ethernet wall outlet) using
the supplied Cat-5 cable and to the mains.
2. Wait for the camera to connect to the network
3. Locate the ADD CAMERA area. In the CAMERA TYPE list click
select Network.
4. In the Location list click
5. You can disable web viewing of the camera by choosing at which arming
mode the camera will be turned off. Clicking an arming mode icon will apply
a small X to it, meaning that at this arming mode the camera will be off.
6. Click to start the camera enrollment
Installing the Visonic PowerLink
and select a location from the list.
22
and