Connections Of External Equipment - Fostex VF80EX Owner's Manual

Connections of external equipment

You can connect various sound sources and external devices to the input and output connectors of the
VF80EX as shown in the example below. When making connection, make sure that the [MASTER] fader
is set to the lowest (" ") position and the [PHONES] knob to the left most ("MIN") position. Otherwise,
your speakers or headphones may damage by the audio noise generated when connecting cables.
Microphones (Dynamic
or condenser type)
<Note>
You cannot use both the [BAL] and
[UNBAL] connectors on INPUT A and
INPUT B simultaneously. Plugging the
[UNBAL] connector disconnects the
[BAL] connector.
Guitar processor
Electric guitar
Digital equipment (CD, MD, DAT etc.)
Headphones
INPUT A
BAL
GUITAR
LINE MIC
UNBAL TRIM
CH ON/OFF
PEAK
AC outlet
Basic Recording/Playback (VF80EX)
INPUT B PHONES ST OUT FOOT SW
L R
BAL
MIX PARAMETER
TRACK
EDIT SCENE SCENE SEQ.
GUITAR
PGM FADER MAP
PAN EQ EFFECT
LINE MIC MIN MAX
UNBAL TRIM
ON/OFF
2TRK MODE
CH ON/OFF BOUNCE MASTERING TRAINING
PEAK
REC EFF
<Note>
Do not power on the machine with non-speci-
fied foot SW connected to the foot SW jack.
When powering on the machine with non-
specified foot SW (latch type foot SW, etc.)
connected to the foot SW jack, there is a case
that the machine does not correctly boot up
with "No Drive!" alert message. In such a case,
power off the machine once, disconnect the
foot SW and then power back on.
Electric bass
POWER PHANTOM S/P DIF / DATA MIDI
INPUT
ON OFF OUTPUT INPUT OUTPUT
25
Amplifier + Speakers etc.
Foot switch (mode 8051)
Top panel
ACCESS
PHANTOM
F1 F2 F3
Rear panel
Sequencer
PC w/sequence software