Selecting The System Scheme; Setting System Parameters; Resetting System Parameters; Carrying Out A Relay Test - Viessmann VITOSOIC 100 Installation And Service Instructions Manual

Selecting the system scheme

Press the following keys:
1. "ANL 1" and the display will
show the respective scheme.
2. OK "SET" flashes.

Setting system parameters

Press the following keys:
1. "ANL" and the display will
show the respective scheme.
2. until the required parameter is
shown (see table on
page 48).

Resetting system parameters

If a different system scheme is selected,
all parameters are returned to their orig-
inal state.

Carrying out a relay test

Press the following keys:
1. "ANL" and the display will
show the respective scheme.
2. select "HND 1" or "HND 2".
HND 1 Relay 1
HND 2 Relay 2
3. for the required scheme.
4. OK to confirm.
See system scheme from page 51.
3. OK "SET" flashes.
4. / for the selected value.
5. OK to confirm.
3. OK "SET" flashes.
Commissioning
43