Table of Contents
Advertisement
<Warning message>
The warning message for copyright shown on the
screen is as follows.
Warning!
You are responsible for use of this digital de-
vice. Be sure to abide by the copyright condi-
tions of the source material.
Press "Enter/Yes" key if you agree with the
above.
<Hint>
The warning message above also appears when
setting the "Digital In setting" menu to "On".
See "Setup mode" on page 130 for details.
<Note>
If you do not agree with the warning message con-
tents, press the [EXIT/NO] key to quit loading.
The display briefly shows "Set Disable" and " Can't
Loading" , then returns to the mode select screen.
If you agree with the warning message contents,
go to the next step to continue the operation.
If you agree to the message contents, press the
6
[ENTER/YES] key.
After showing "Set Enable!", the display shows the
screen for selecting the song(s) to be loaded.
If there is more than one track recorded on the au-
dio CD, " " flashes, showing that you can select a
desired track. If there is only one track recorded on
the audio CD. " " is not shown on the screen.
<When only one track is recorded>
<When more than one track is recorded>
or
Save/Load of Song data
Use the [JOG] dial to select a track number to be
7
loaded and press the [ENTER/YES] key.
The destination program number starts flashing,
which is one greater than the highest program num-
ber among those available on the current drive.
This means a track is going to be loaded to a new
program.
For example, if there are 4 programs available on
the current drive, the destination program number(s)
on the current drive and then perform step 7 above
again. If there are already 99 programs on the cur-
rent drive, "Disk Full!" appears and no destination
program number is shown. In such a case, delete
the unnecessary program(s) on the current drive and
then perform step 7 above again.
Flashing
By rotating the [JOG] dial, you can select "NON", as
well as a "Program". When performing the load op-
eration, tracks that are set to "NON" are not loaded.
While the program number is flashing, press the
8
[ENTER/YES] key.
The flashing program number changes to light sol-
idly, showing that the first track is ready to be loaded
to the program.
To load more than one track, repeat steps 7 through
8 above.
The following screen example shows that tracks 1
and 2 will be loaded to program 05 and 06 respec-
tively. The track time is also shown to the left of
each program number.
<Note>
When loading from a audio CD, no title is shown
when selecting the track.
119
Advertisement
Table of Contents
