Analog Inputs - TerraTec PHASE 22 Manual

Analog inputs

The analog inputs of the PHASE 22 System feature high-quality
preamps with which you can manually control the converters.
Here, you can connect the AUX or TAPE outputs of a mixing
board, instruments with line level output, a tape recorder or similar
peripheral gear.
The PHASE 22 system has two high-quality analog inputs, which can be independently
addressed. The connections have been realized as 1/4" jacks and offer a balanced signal
path to minimize interference. Naturally, it is also possible to connect unbalanced mono
jacks. The unused signal phase is automatically connected to the analog ground.
If the level of a connected device is too low, you can increase the signal by up to 18 dB in
0.5 dB steps with the controllers in the PHASE Control Panel. In the drivers as well as in
the PHASE ControlPanel, the inputs are viewed as a stereo pair. As a rule, you can also
combine the two channels for mono use in common audio editors.
Practical tip: While recording, try to achieve as high a recording
level as possible to benefit best from the wide dynamic range of
the 24-bit converter. As a rule of thumb for good recordings, al-
ways take the following into account: a clean "take" is much more
valuable than the best plug-in for later sound correction.
PHASE 22 (English) 23