Controlling The Engines; Preset Handling - TC Electronic UNIT•Y Manual

CONTROLLING THE ENGINES

9
Each UNIT•Y Engine has its own page with some parameters controlled by the cursor and
the wheel, while others are laid out on the faders.
Parameters on the faders may be dynamically automated.
Engine 1: Fader 1-8
Engine 2: Fader 9-16
Output Mix: Stereo Fader 1-4
To switch between the UNIT•Y screens, several methods may be used.
If Fader Touch Select is enabled on the 02R Preferences page, touching fader 1-8 will take
you to the UNIT•Y screen Engine 1. Touching fader 9-16 will take you to Engine 2 and
touching one of the Stereo faders will take you to the Main screen.
You may also switch screens by pressing Select buttons.
If one of the UNIT•Y screens are shown, the Main screen is shown when you press one of
the select buttons above the Stereo Faders.
To go to the Engine 1 screen, press one of the select buttons above fader 1-8.
To go to the Engine 2 screen, press one of the select buttons above fader 9-16.
Finally you may move between the screens by using the cursor exits on the screen
boundaries.
All preset handling is done on the UNIT•Y Main screen.
Dynamic automation of Engine parameters is carried out on the Engine screens.