Utility Page; Serial Number, License Codes - TC Electronic UNIT•Y Manual

UTILITY PAGE

35
A Utility page is provided to perform these functions:
• Display of UNIT•Y software revision and Serial number.
• UNIT•Y self diagnostics test.
• Entering License codes for software modules.
• Invoking other special functions.
• Clearing the UNIT•Y Preset RAM and reverting to factory Presets.
Getting to the Utility page
You probably don't need to access the Utility page on a daily basis, but it may be entered
from the Main page by typing Preset name "UTILITY" or "@@" and pressing "DMP". If you
wish to go here often, you can name a preset like that for easy access.
License Codes and Reference Codes
To access different software options, you have to enter a License code in the Command
display and then press ENTER. To get a license code, you may be asked about your
Reference code. This code is found on the Utility page within the brackets succeeding the
name of the software module you require. The Status display will verify the process.
Card Status
To see a license and configuration status of the selected UNIT•Y card, write "STATUS" or
"ST" in the Command line, and press ENTER.
ADAT and TDIF format
If you use the ADAT/TDIF DIO extension card, the Utility page is used to set-up format
type, format conversion etc. Refer to the papers included with the card.
Special functions
New special commands may be issued from the Utility page. In that case, they will be
described on the TC web-site.
Status display
Command display