Sends - TC Electronic UNIT•Y Manual

SENDS

Getting signals to the UNIT•Y card is partly done on the UNIT•Y Main screen and partly on
the 02R DIO screen shown below.
Routing on the 02R DIO screen and on the UNIT•Y main screen may be different from
Scene to Scene.
Note slot number
Note:
To access Main L/R Insert, click
Enter twice in these locations.
Insert return is set on the
Main page by selecting RET
L.R.
02R Slot Output Select Screen
The sends to the UNIT•Y engines may be chosen from the selected signals shown above.
Engines can be fed from Aux 1, 2, 5, 6, 7 or 8, Bus 5-8, Main L/R or Main Insert. If a
UNIT•Y card is placed in slot 1 or 2, Mic channels 5-8 or 13-16 also may be used as sends.
If you press Enter twice on the L/R icons at bus 5 or 6, Engine 1 may be used as a Stereo
Bus Insert processor.
Note: If you've got more than one UNIT•Y card, it's possible to specify more Stereo Bus
Inserts at a time, but this assignment is not valid. Only use one Insert at a time.
Example
To send Aux 7 to Engine 1, press the DIO button in order to get to the 02R Output Select
screen as shown above.
In column 7 go to the Aux icon. If it shows "1", click Enter twice to change it to "7".
Go to the UnitY main screen by holding the Flip button. Position the cursor on the Input
Select Icon and turn the Parameter Dial until "Aux 7" is displayed.
Now Aux 7 is routed to both Unit•Y Engine 1 and the internal Yamaha effect 1.
Choose between these four signals on the Unit•Y main screen
11
Note:
To access Aux 7 and 8, click
Enter twice in these locations.