TC Electronic UNIT•Y Manual page 41

YAMAHA 02R V2 FUNCTIONS 41
Bus outs can be paired. See "Pairing Channels" on page 184 of the User's Guide.
7. Cascade Message Link
When several 02Rs are cascaded together, the master 02R can control a number of
functions of the slave 02Rs via MIDI. See "MIDI Link" on page 232 of the User's Guide.
8. Communications Speed
The communications speed settings have been moved to the UTILITY 4/4 (Battery Check)
page. See "Communication Speed" on page 214 of the User's Guide.
9. Cue Send Dim Level Control
The Cue Dim control sets the level to which cue outputs are dimmed when talkback is
engaged. See "Solo" on page 196 of the User's Guide.
10. Channel Delay On/Off Parameter on View Page
The Channel Delay function can be turned on or off from the View page. See "View" on
page 44.
11. Fader Start
When the Fader Start preference is checked, a MIDI Note On message is transmitted when
channel faders are raised from infinity (oo). "Fader Start" on page 163 and "Preferences"
on page 198 of the User's Guide.
12. Initial Data—Faders Nominal or Minimum
A preference can be set so that recalling scene memory 0 causes all channel faders to
move to either the nominal or minimum position, the latter being the default. Aux and bus
master faders move to the nominal (0.0 dB) position regardless of this preference. See
"Initial Data and UNDO Memory" on page 129 and "Preferences" on page 198 of the User's
Guide.
13. Input Patching
The Input Patching function allows you to select the signal sources for MIC/LINE channels
1 to 24 and TAPE channels 1 to 16. Bus outs can be patched though to the TAPE channels
for bus out monitoring and subgrouping. See "Input Patching" on page 206 of the User's
Guide.
14. MIDI Control Changes
MIDI Control Change messages can be used to remotely control 02R mix parameters,
including faders, ON buttons, EQ, and pan. See "MIDI Control Change Assign" on page
164 of the User's Guide. A Parameter to Control Change Table is provided on page 256 of
the User's Guide.