Troubleshooting - TC Electronic TC STEREO CHORUS/FLANGER User Manual

TROUBLESHOOTING

In case you encounter any difficulties, please go thru this
troubleshooting before calling the service center
ERROR
No "on" LED - click the bypass footswitch.
- is there sound?
- try another AC outlet.
No Sound - AC outlet OK?
- try to get sound through your amp.
- are the cables ok? Try others.
- move all switches back and forth.
- try another sound source.
- test in mono (see chorus problem).
20
CHECK
without using the TC SCF.
TROUBLESHOOTING
ERROR CHECK
Distortion INPUT GAIN adjusted too
high - 0dB max should be
put in - install an input
attenuator if necessary - try another
signal source - try another cable -
does the OVERLOAD LED light?
Chorus Effect Do not mix the two outputs together
disappears these are in anti-phase.
To make a mono-compatible effect,
1) Use one output only or
2) With a "splitbox" you can connect
the direct signal to the input of the
SCF as well as to Left side of the
stereo, the SCF Stereo Out jack to
the RIGHT side. Now, set the
MODE switch at P.M. and
21