TROUBLESHOOTING
ERROR
Distortion
Chorus Effect
CHECK
INPUT GAIN adjusted too
high - 0dB max should be
put in - install an input
attenuator if necessary - try another
signal source - try another cable -
does the OVERLOAD LED light?
Do not mix the two outputs together
disappears these are in anti-phase.
To make a mono-compatible effect,
1) Use one output only or
2) With a "splitbox" you can connect
the direct signal to the input of the
SCF as well as to Left side of the
stereo, the SCF Stereo Out jack to
the RIGHT side. Now, set the
MODE switch at P.M. and
21