TC Electronic HALL OF FAME 2 REVERB User Manual

TC Electronic HALL OF FAME 2 REVERB User Manual

Iconic reverb pedal with groundbreaking mash footswitch and shimmer effect
Hide thumbs Also See for HALL OF FAME 2 REVERB:

Advertisement

HALL OF FAME 2 REVERB
Iconic Reverb Pedal with Groundbreaking
MASH Footswitch and Shimmer Effect
User Manual
Rev. 1.2, 2017-08-22

Advertisement

Table of Contents
loading

Summary of Contents for TC Electronic HALL OF FAME 2 REVERB

  • Page 1 HALL OF FAME 2 REVERB Iconic Reverb Pedal with Groundbreaking MASH Footswitch and Shimmer Effect User Manual Rev. 1.2, 2017-08-22...
  • Page 2: Table Of Contents

    HALL OF FAME 2 REVERB User Manual Table of Contents Important Safety Instructions ........3 Legal Disclaimer ............. 3 Limited warranty ............3 1. About this Manual ............. 4 2. Introduction ............... 4 2.1 Unpacking ................4 2.2 True Bypass ................4 2.3 Setting up ................
  • Page 3: Important Safety Instructions

    HALL OF FAME 2 REVERB User Manual 9. Do not defeat the safety purpose of the polarized 20. Please keep the environmental aspects of battery Important Safety or grounding-type plug. A polarized plug has two blades disposal in mind. Batteries must be disposed-of at a Instructions with one wider than the other.
  • Page 4: About This Manual

    The original HALL OF FAME REVERB delivered some of the most iconic reverb This TC Electronic product supports TonePrints. To learn more about TonePrints, sounds of all time, but HALL OF FAME 2 REVERB extends that legacy of go to tcelectronic.com/toneprint/ innovation dramatically.
  • Page 5: Editing Toneprints With Toneprint Editor

    “7.2 Changing the battery”. • (2) USB port - Use the standard Mini-B USB port on your TC ELECTRONIC effect TonePrint Editor is absolutely free! pedal to connect your pedal to a computer. If there should be firmware Obtaining TonePrint Editor updates for this pedal, they can be installed using the USB port –...
  • Page 6: Effect Controls

    4.4 Effect controls SPRING reverb Please note that the knob assignments on your TC Electronic pedal are the default The Spring reverb has been designed to reproduce the sound of the old spring assignments. Using the TonePrint editor, you can rewire all knobs so they control reverbs, such as the ones used in vintage guitar amps.
  • Page 7: Operation

    HALL OF FAME 2 REVERB User Manual 5. Operation 5.1 Signal chain placement The Hall of Fame 2 can be used several ways depending on your situation. While there isn’t necessarily a right and wrong use, here are the most common scenarios.
  • Page 8: Bypass Mode

    • Press and hold the footswitch on your TC pedal. If your TC pedal has more Use this mode when you place your TC Electronic effect pedal in a parallel effects than one footswitch, press and hold the leftmost footswitch.
  • Page 9: Changing The Battery

    HALL OF FAME 2 REVERB User Manual 9. Specifications 7.2 Changing the battery If you need to change the battery of your TC ELECTRONIC effect pedal, Bypass mode True Bypass (Buffered Bypass optional) proceed as follows: Input connector 2 x 1/4" TS, unbalanced, mono •...
  • Page 10 HALL OF FAME 2 REVERB User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION TC ELECTRONIC HALL OF FAME 2 REVERB Music Group Services NV Inc. Responsible Party Name: 5270 Procyon Street Address: Las Vegas, NV 89118 +1 702 800 8290 Phone Number:...
  • Page 11 HALL OF FAME 2 REVERB User Manual...

Table of Contents