The Display; Miscellaneous; Factory Presets; Midi Channel - TC Electronic M300 User Manual

Factory Presets

The M300 holds no conventional factory
presets. When all the controllers are in 12
o'clock position the M300 is in "neutral",
meaning that all parameters are set as
suggested by TC Electronic. Combining the 16
positions of both the Multi-effect and Reverb
selectors you actually have 256 "factory"
presets.
MIDI CH.
Via an external MIDI device it is possible to
recall presets and control parameters in the
M300. For the external device to communicate
with the M300 it is essential that they
communicate on the same MIDI Channel.
The M300 can be set to receive on all MIDI
channels, none or all.
• Press and hold PRESET ON/OFF. The
current selected MIDI channel is displayed.
Assuming the M300 is "right out of the box" or
that you have performed a Reset procedure as
described on page 31, the display now shows:
- indicating that channel 1 is selected and the
M300 can receive MIDI information on
channel 1.
• Use the UP/DOWN arrows to select MIDI
channels 1 to 16.
• "O" indicates Omni which means that the
M300 can recive MIDI information on all
channels.
• "OF" indicates that the M300 will ignore any
incoming MIDI messages.
• Press LOAD to verify and exit menu.

SysEx ID

The M300 SysEx ID is always identical with the
set MIDI Channel.
22

MISCELLANEOUS

Application Software version
This number indicates the current loaded
application software and is relevant only for
sevicing purposes.
• Press and hold PRESET ON/OFF and use
The display will flash between "AP" (for
application) and the current loaded application
software.
Front Software version
This number indicates the current loaded front
software and is relevant only for sevicing
purposes.
• Press and hold PRESET ON/OFF and use
The display will flash between "Fr" (for
front-software) and the current loaded front
software number.
the UP/DOWN arrows to select "AP" as
displayed below.
the UP/DOWN arrows to select "Fr" as
displayed below.