TC Electronic M300 User Manual page 14

Setup
Routing Schematic
12
TYPICAL SETUPS
"Parallel Setup"
This setup utilizes the M300 as a Dual
processor on a mono signal with a common
stereo Output.
• On the rear panel select Dual S/R routing by
• Connect AUX1 (or any) to Left Input.
• Connect the M300 Left and Right Outputs to
• Set MIX to 100% wet, as you in this setup do
• Set Input level to 12 o'clock position.
• Set BALANCE to 12 o'clock position.
• Select Reverb type and Multi-effect type
• Set the AUX Return level on the mixer to
• Now slowly turn up the AUX Sends
• Adjust/fine-tune the M300 Input level so the
Controlling M300 via MIDI
Various functions in the M300, such as
preset recall and Tap Tempo, can be
controlled via an external MIDI device.
This example shows how to control the
M300 with a TC Electronic G•Minor*
footcontroller. A complete list of CC values
can be found on page 31.
• Connect MIDI Out on the G•Minor to MIDI In
• Connect MIDI Out on the M300 to MIDI In on
You are now able to recall the stored presets in
the M300 using the UP/DOWN switches on the
G•Minor. You can also tap the Global Tempo
using the HOLD switch.
* Detailed information on the G•Minor can be
leaving the ROUTING switch in the "IN "
position.
NO connections to Right Input. The Left Input
signal is automatically fed to the Right Input
internally in the M300.
the Stereo AUX L/R returns of either AUX 1
or AUX 2.
not want the direct signal to pass through the
M300.
using the selectors on the front panel.
approx. 50%.
Input LED on the front panel often is Orange
but only rarely peaks at Red color.
on the M300.
the G•Minor.
found in the G•Minor manual. Feel free to
download from www.tcelectronic.com
(analog Input only)