TC Electronic M300 User Manual page 13

Setup
M300 Routing Schematic
TYPICAL SETUPS
Serial Setup
This setup utilizes the M300 as a Multi-
effects processor connected in serial to a
Reverb. It is ideal when you wish to add
Reverb to a signal already processed by
one of the Multi-effects. The illustrated
setup is a typical live instrument setup.
• On the rear panel select SERIAL routing by
• Connect Line signal directly from your
• Connect the M300's Left and Right Outputs
• Set Input level to 12 o'clock position.
• Set MIX level to 12 o'clock position.
• Set BALANCE to 12 o'clock position.
• Adjust/fine-tune the M300 Input level so the
• Select Reverb type and Multi-effect type
• Now fine-tune:
leaving the switch in "OUT " position.
instrument or from a DI-box to the M300
Inputs. (use Left Input for mono signals).
to mixer or amplification.
Input LED on the front panel often is Orange
but only rarely peaks at Red color.
using the selectors on the front panel.
- MIX between wet and dry signal
- BALANCE between the two effect Engines.
11