Auto Track Function; Auto Track - Tascam SS-CDR200 Owner's Manual

To stop sync recording, use the
•
or push the remote control
.
OFF
If the sync level is too high
„
If the sync level setting is too high, you may have
problems such as failing to capture the beginning of a
song that begins with a low volume.
Level
SYNC_LVL
This part
is not
recorded
If the sync level is too low
„
Sync recording will not begin from recording standby, if
the source you are recording has a high noise level.
Level
Noise level is higher than the SYNC LEVEL,
so recording never starts
SYNC_LVL

Auto Track function

Auto Track recording is a function that automatically
creates a new track with a new number when a set
condition is met during recording.
Use the menu to enable Auto Track mode and make
detailed settings. In addition, Auto Track mode can also
be turned ON/OFF using the remote control A.TRACK
button.
When the Auto Track function in ON,
appear highlighted on the
FUNCTION
Auto Track settings can be changed at any time, so you
can change settings while recording.
NOTE
If you have recorded in WAV format, you can also use
editing functions to divide or join tracks after recording.
(See "Dividing files" on page 57 and "Combining files" on
page 58.)
Using the menu
„
1 Press the MENU [JOG] button (or remote control
MENU button) to open the
2 Open the menu.
REC
3 Select .

AUTO TRACK

menu item
REC SYNC
button to set to
SYNC SYNC
Recording starts
Time
Time
will
AUTO TRACK
screen.
screen.
MENU
4 Press the MULTI JOG dial or , [LOCK] button (or
remote control ENTER or t button) to move the
cursor right to select the value.
5 Turn the MULTI JOG dial (or push remote control 5
and b buttons) to select one of the following Auto
Track modes.
OFF (default value)
New tracks will not be created automatically.
LEVEL
A new track will be created when the signal exceeds
the auto track level (
AUTO TRACK
after having stayed below it for two seconds or longer.
Level
Auto track level
DD
When recording a digital source (CD, DAT, MD) via the
DIGITAL IN jack, a new track will be created when a
track division is detected in the source.
However when recording an analog source or a digital
source other than those listed above, this will work in
the same way as LEVEL mode, and new tracks will be
created in response to the input level.
TIME
A new track will be created at the set time interval
( screen
AUTO TRACK INTERVAL
6 If you set AUTO TRACK to anything other than
press the , [LOCK] button (or remote control t
button) to open the
AUTO TRACK
the current mode.
7 Set the following items according to the mode.
LEVEL mode
•
LEVEL
Sets the level that triggers the Auto Track function.
Options: –
–72 dB
value: )
–54 dB
•
DELAY
Sets the time (in frames) from when a signal
exceeding the LEVEL is detected until a new track is
created (one frame is 1/75th of a second).
Options: –
–75 f
)
0f
TASCAM SS-CDR200/SS-R200/SS-R100
5 – Recording
screen value)
LEVEL
New track
created
2 sec.
Time
value).
OFF
setting screen for
(6dB steps, default
–24 dB
(frame, default value:
+75 f
45
,