Assigning Inputs; Figure 1.7: Assigning Inputs To Tracks - Tascam DP-01 Owner's Manual

Assigning inputs

Assigning inputs
When we talk about "assigning" inputs, we are talking about linking the sig-
nals from the two inputs to the tracks.
You can record on up to two tracks at a time. This means that the same input
can be assigned to two tracks at the same time (you can't then use the other
input) or the two inputs can be assigned to different tracks. You can't assign
both inputs to the same track at the same time.
Press and hold
one of the
ASSIGN keys
...
Press and hold the
ASSIGN
are assigning ( or
A B
...
While holding down the
which you are assigning the input.
The key flashes rapidly.
REC
...
If you want to assign the input to another track, you must first clear
the current assignment (see below), and then re-assign the input.
Note that the
REC
input flashes when you hold down the
Clearing an assignment
assignments and while holding the
ments by pressing a flashing
20
TASCAM DP-01 Owner's Manual

Figure 1.7: Assigning inputs to tracks

key corresponding to the input signal you
).
key, press the
ASSIGN
key of the first track to which you assigned the
ASSIGN
Hold down the
ASSIGN
key, clear current assign-
ASSIGN
key (which then stops flashing).
REC
And then press
one of the 8
REC keys
key of the track to
REC
key.
key to check current
Press and
and either
SHIFT
of the keys ( or
ASSIGN A
turn the inputs on or off as
shown by the indicator. You may.
turn off unused inputs to reduce
noise.
hold
) to
B