Changing The Tcp/Ip Setting; Ip Address; Gateway - Fostex DV40 Operation Manual

Changing the TCP/IP setting

There are cases that the TCP/IP settings must be changed. For example, if 2 x DV40s exist in
a single network environment, the IP Address on one of the DV40s must be changed. This
section describes how to change the TCP/IP settings.

• IP Address

The IP Address on DV40 is set in this menu.
1. Rotate the jog dial to select "IP Addr.? [192.16" and press the [ENTER/YES] key.
To check the full digits of IP address, press the [SKIP/CURSOR >>I] key once. If you do so, the
following will appear on the DV40 FL display.
Now you can see that the current IP Address setting on DV40 is [192. 168. 1. 64].
2. Press the [ENTER/YES] key.
If the [ENTER/YES] key is pressed, the section "192" starts flashing.
3. Move the cursor and change the IP Address.
Move the cursor by the [SKIP/CURSOR >>I] or [SKIP/CURSOR I<<] key and rotate the jog dial to
change the IP Address. The alphanumeric keys can be also used to change the IP Address.
4. Press the [ENTER/YES] key.
Pressing the [ENTER/YES] key defines the change on the IP Address.

• Gateway

The Gateway should be set when the Gateway server exists in the network DV40 is con-
nected. If there is no Gateway server exists, you do not have to set the Gateway.
1. Rotate the jog dial to select "Gateway? [192. 16" and press the [ENTER/YES] key.
To check the full digits of Gateway, press the [SKIP/CURSOR >>I] key once. If you do so, the
following will appear on the DV40 FL display.
Now you can see that the current Gateway setting on DV40 is [192. 168. 1. 2].
SETUP
SETUP
SETUP
Flashing
SETUP
SETUP
13-5
Flashing
Flashing