Changing The Label - Snom 360 User Manual

[
S N O M
360 to boot completely. Just before boot-up is complete, all
LEDs on the expansion module will fl ash once. The expansion
module is now ready for operation.
• Currently, one additional expansion module with 42 function
keys can be connected to the snom 360. Its power is supplied
by the phone; an external power adapter is not necessary.
• When you press the question mark key "?" on the phone's
keypad the display will show the expansion module's
version (EK: 1.1, for example) following the software
version of the phone itself.
Programming the expansion module
Confi gure the function keys on the expansion module using the
built-in web interface of the phone. These keys can be used for Line,
Destination, Intercom, Park Orbit, or Voice Recorder mapping. The
default operation is Line. The LEDs associated with each key will refl ect
the status of that line, e.g. ringing, on-hold, connected call, etc.

Changing the label

The label panels for the function keys are included on a separate sheet
enclosed with the operating instructions. Cut out the label you wish
to use. To change the label panel, press the fl exible cover together
between your index fi nger and thumb and lift it out. The label panel
can now be changed.
© 2005 snom technology Aktiengesellschaft.
All Rights Reserved. This document is supplied by snom technology AG. No part of this
document may be reproduced, republished or retransmitted in any form or by any means
whatsoever, whether electronically or mechanically, including, but not limited to, by way of
photocopying, recording, information recording or through retrieval systems, without the
express written permission of snom technology AG.
snom technology AG reserves the right to revise this document and make changes at any
time and without the obligation to notify any person and/or entity of such revisions and/or
changes.
3 6 0 E
X P A N S I O N
]
M O D U L E
• 3