Advertisement
307-01-6
ASSEMBLY (Continued)
20. Install the reverse band actuating lever shaft
into the case and into the reverse band actuating
lever.
21. Install the No. 10 needle bearing into the case.
22.
CAUTION: Do not damage the seal
against the case during assembly.
Install the output shaft ring gear, hub and seal.
23.
CAUTION: Always install a new
output shaft retaining ring.
Install a new output shaft retaining ring.
Automatic Transaxle/Transmission
24. NOTE: Install the output shaft sleeve with the
25. Install low/reverse planetary carrier needle
cone facing up. This sleeve will snap into place
when correctly installed.
Install the output shaft sleeve.
bearing (No. 9) onto the output shaft ring gear
and hub assembly.
2005 Mustang, 12/2004
307-01-6
Advertisement
