Advertisement
307-01-4
ASSEMBLY (Continued)
9. Assemble the manual valve inner lever and
parking lever actuating rod as shown.
10.
CAUTION: Align the flats on the
manual valve inner lever with the flats on
the manual control lever shaft.
Install the manual control lever shaft.
11. Install the manual valve inner lever onto the
manual shaft and loosely install the nut.
Automatic Transaxle/Transmission
12.
13.
CAUTION: Use care not to damage
the fluid pan rail surface when installing the
retaining pin.
NOTE: Align the manual control lever shaft
alignment groove with the manual control lever
shaft spring pin bore in the transmission case.
Install the manual control lever shaft spring pin.
• Tap the manual control lever shaft spring
pin into the transmission case.
CAUTION: To avoid damage, do not
allow the wrench to strike the manual valve
inner lever pin.
Tighten the nut.
• Tighten to 48 Nm (35 lb-ft).
2005 Mustang, 12/2004
307-01-4
Advertisement
