Amana Bottom Mount Refrigerator Service Manual page 6

Installation Instructions
8. Remove (4) 1/4" screws with a magnetic extended
screw driver.
9. Pull air grille assembly forward.
Air grille
assembly
1/4" screws
10. Verify operation by plugging in power cord. Power
switch will be shipped in the on position and the
showroom switch will be shipped in the off position.
Display should flash. Press any key. There is a 6
minute delay before refrigerator starts. Verify
position of each switch if there is no power to
refrigerator.
11. Pull end of nylon cord around refrigerator side (side
without 1/4" panel installed, if any) level with top of
refrigerator door. Tape cord in place.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, disconnect
power to refrigerator using power switch
before performing any installation procedure.
After performing installation procedure,
connect power using power switch.
RS1200001
Showroom
switch
Power
switch
12. Roll refrigerator into cutout to within 3" of being
flush with kitchen cabinets. To avoid kitchen cabinet
damage, place cardboard between kitchen cabinets
and refrigerator. Push cardboard back with
refrigerator and remove cardboard when refrigerator
is in place. Remove power cord slack by pulling
nylon cord straight out while pushing refrigerator
completely into place. Power and nylon cord will
rest along refrigerator side.
Pull nylon
cord straight
out
13. Level refrigerator by turning front and rear leveling
wheel bolts clockwise to raise refrigerator and
counterclockwise to lower refrigerator. Rotate
stabilizing legs until firmly in place against floor.
14. Align refrigerator with sides of kitchen cabinets
using leveling bolts.
15. Secure lag bolts by removing center air grille blade.
Screw lag bolts securely into 2x4 mounting board
using a magnetic 6" extension socket. See
"Installation Specifications".
16. Push extra nylon cord back in along side of
refrigerator out of sight or cord can be flush with
refrigerator.
6
Power cord
must rest
as shown
Lag bolts
November 1996