Resetting The Device - Honeywell DOLPHIN 6500 Quick Start Manual

Step 2: Charge the Batteries
Dolphin terminals ship with both the main battery pack and internal
backup battery significantly discharged of power. Charge the main
battery pack with the Dolphin charging cable for a minimum of 5 1/2
hours before initial use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use
of any non-Honeywell peripherals, cables, or power adapters may cause damage not
covered by the warranty.
Step 3: Boot the Terminal
The terminal begins booting as soon as power is applied and runs by
itself. Do NOT press any keys or interrupt the boot process.
When the boot process is complete, the Desktop appears and the
terminal is ready for use.

Resetting the Device

Soft Reset:
Hard Reset:
1
2
3
Using the stylus, press the
turns white and the decode/scan LED flashes blue for
approximately 10 seconds.
28-key: Press and hold the
using the stylus, press the
52-key: Press and hold the
buttons and then using the stylus, press the
button. The screen turns white and the decode/scan
LED flashes blue for approximately 18 seconds.
Reset
button. The screen
Power
button and then
Reset
button.
Blue Z Power
and ( )
Reset
5