Viking PB-100 Technical Practice page 4

Polling bridge and phone line interface

Hide thumbs Also See for PB-100:

Application note (8 pages)

Technical practice (5 pages)

Technical practice (13 pages)

page of 4

/ 4
Bookmarks

B. System Requirements

1. Hardware Requirements

• IBM Compatible personal computer with: Windows XP (service pack 2 or higher), Vista, or Win7

• PB-100 hardware

• Available RS-232 serial port or USB port

• Male sub-D 9 pin cable or USB to RS-232 converter cable (provided with PB-100 hardware)

• Windows compatible sound card

• 5MB minimum free hard drive space for each installation

• 8MB of free physical RAM for each Viking application running

2. Software Requirements

• Internet Explorer or Netscape Navigator Version 4 or newer to navigate CD contents.

• Adobe Acrobat Reader

C. Installing Software

Step 1. Connect the hardware as shown in "Hardware Installation".

Step 2. Insert the Viking master CD to start the program.

Step 3. Follow the instructions on the CD.

Note:

D. Un-Installing Software

Step 1. Go to "Control Panel", then select "Add/Remove Programs".

Step 2. Select the Viking software you want to remove.

Step 3. Click "Remove".

VIKING

OFF

STATUS

1 2 3 4

A. 1600A Series Polling

For polling 1600A Series products, set Dip switches 1 and 3 to ON, 2 and 4 to OFF.

B. AES-2000 Programming

Using the PB-100 is the only way to program the AES-2000. The PB-100 provides the modem for data transmission as well as a

phone connection for recording the audio directory. Dip Switches 1 and 2 must be in the ON position 3 and 4 OFF. On some phone

lines, there may be excessive noise and the AES-2000 may have trouble receiving the data from the PB-100. If this happens, set

Dip Switch 4 to the ON position to attenuate the unwanted noise.

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries

assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

DOD# 232

version 4.x or newer to view Product and Software Documentation.

POLLING BRIDGE

MODEL PB-100

RESET

VIKING ELECTRONICS, HUDSON WI 54016

1 2 3 4

Printed in the U.S.A.

Switch

ON/OFF

Description

OFF