Viking PB-100 Technical Practice page 2

W a r r a n t y
W a r r a n t y
H a r d w a r e
H a r d w a r e
The PB-100 comes complete with a telco cord, serial cable, USB to RS-232 converter cable, audio cables and a 12V DC power adapter.
Step 1. Using the telco cord, connect a phone line to the rear panel jack labeled "LINE". If the PB-100 is to be used to make
AES-2000 audio recordings. A standard phone can be plugged into the "PHONE" jack.
Step 2. Connect one end of the 9 pin serial cable into the jack labeled "SERIAL DATA" and the other end into an open serial port
of the PC. If a serial port is not available, use the included RS-232 to USB cable to connect to a USB port.
Step 3. If audio is to be used through the PB-100, connect the "Audio In" or "Mic In" of the sound card to the "AUDIO OUT" port
of the PB-100.
Step 4. Plug the 12V DC power adapter (included) into the rear panel power jack.
Serial
Port
USB
Port
Mic
In
2
I n s t a l l a t i o
I n s t a l l a t i o
SERIAL DATA
n
n
PHONE LINE
AUDIO AUDIO
(RS-232)
IN OUT
USE ONLY LISTED
CLASS 2 POWER
SOURCE 12VDC
O.5A MAX