Lathem DWA Series Setting Instructions

The following setting instructions refer to the display of the DWA, DWA18-1 and 4000DWA Series.
"Old Style" Keypad
EDAY SAT
0 7 ON
SUN
1 8 OFF
MON
2 9 HD
TUE
3 AM CLR
WED MEM
4 PM CLR
THU
5 WK CLK
FRI
6 CKT *
"New Style" Keypad
SET SET
TIME DAY
12/24 HR SIGNAL
DISPLAY OFF
CLEAR
RESTART SIGNAL
SUN MON
WED THU
SAT REV
MANUAL TEST
SIGNAL BATT
Tip Set DWA.pdf
Setting the Time DWA Series
Tip:
To set the time on an "Old Style" keypad:
! If you have a 4000DWA Series, wait until you here the clock "click", make
a sample registration and note the time
! Set the Time of Day by pressing
1. Current Day of Week
2. WK
3. AM or PM
4. Hour and Minutes (set the minutes one-minute ahead of the clock
time)
5. Wait until the clock "clicks" and press CLK
Example: To set the time to Monday, 9:30AM press:
MON
2 WK
Note: A colon in the upper left area of display indicates PM
To set the time on a "New Style" keypad:
PGM
! If you have a 4000DWA Series, wait until you here the clock "click", make
SIGNALS
a sample registration and note the time
! Set the Day of Week by pressing
SIGNAL
1. SET DAY
LENGTH
2. Current Day of Week
3. RUN
! Set the Time of Day by pressing
NEXT
SIGNAL 1. SET TIME
2. Press FWD or REV to set the display one-minute ahead of the clock
time
3. Wait until the clock "clicks" and press RUN
TUE
Example: To set the Day of Week to Monday press:
FRI
SET
DAY MON
FWD
Example: To set the Time of Day to 9:30AM press:
RUN SET
TIME FWD
Note: A colon in the upper left area of display indicates PM
Lathem Time Tech Tips
AM 9 3 0
RUN
RUN
CLK
Page 1 of 1