FoodSaver Vac 1050 User Manual page 8

T H E F O O D S AV E R U S E R M A N U A L
How to Use the Manual Seal Button
Place the open end of the bag
4
IMPORTANT: Make sure the open end of the bag touches the blue
label on the bottom of the vacuum channel.
Close the lid.
5
Lock the lid by pulling the locks forward on both sides until they
6
snap into place. (You may need to press down lightly on the stars
while pulling the locks forward.)
12
the vacuum channel.
down into
T H E F O O D S AV E R U S E R M A N U A L
Press and release the On button.
7
The lights will turn on in sequence
as the Vac 1050 vacuums the bag.
To stop the vacuum process before
8
all the air is removed, press and
release the Manual Seal Button.
The sound will stop and the lights
will turn off when bag is sealed.
The locks on the sides will release
automatically. Lift up the lid and
remove the bag.
Vacuum packaging is complete.
9
NOTE: It takes approximately three seconds to stop the vacuum
process and seal the bag. If you are using a small bag or pack-
aging a fragile item, we recommend that you press down on the
Manual Seal Button immediately after pressing the On button.
13