Important Safeguards; Troubleshooting - FoodSaver Vac 1050 User Manual

T H E F O O D S AV E R U S E R M A N U A L

Important Safeguards

For Your Own Safety, Always Follow These Basic Safety
Precautions When Using the FoodSaver Vac 1050:
Read the instructions carefully.
1
Do not use the Vac 1050 on wet or hot surfaces, or near a heat
2
source.
Do not immerse any part of the Vac 1050, power cord or plug
3
into water or other liquid.
To disconnect, unplug the power cord from the electrical outlet.
4
Do not disconnect by pulling on the cord.
Do not operate the Vac 1050 with a damaged power cord or
5
plug. Do not operate the Vac 1050 if it malfunctions or is in any
way damaged. If the cord or the machine is damaged, it must be
returned to an authorized service center.
Do not use an extension cord with the FoodSaver 1050.
6
Use only accessories or attachments recommended by Tilia, Inc.
7
Use the Vac 1050 only for its intended use.
8
Closely supervise children when using any electrical appliance.
9
Do not allow the Vac 1050 to be used as a toy.
10 120v Machines Only:
blade is wider than the other). To reduce the risk of electrical
shock, this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. Do not
modify the plug in any way.
34
The Vac 1050 has a polarized plug (one
T H E F O O D S AV E R U S E R M A N U A L

Troubleshooting

Nothing Happens When the On Button Is Pressed:
Make sure the power cord is firmly plugged into the electrical outlet.
1
Make sure the power cord is not damaged in any way.
2
Make sure the electrical outlet is operative by plugging in
3
another appliance.
Wait 20 minutes to allow the Vac 1050 to cool off, and then try
4
using it again. The Vac 1050 will shut off automatically if it
becomes too hot. To keep the machine from becoming too hot:
Wait at least 20 seconds for the machine to cool down after
a.
vacuum packaging and/or sealing before attempting to vacuum
and/or seal another bag.
Keep the lid open before vacuuming and/or sealing another bag.
b.
Air Is Not Removed From the Bag:
Make sure the open end of the bag is resting entirely inside the
1
vacuum channel. Make sure you are not putting the edge of the
bag beyond the vacuum channel.
Check the bag for leaks. Seal the bag with some air in it. Submerge
2
it in water and apply pressure. Bubbles indicate a leak. If the bag
has a leak, you need to use a new bag.
If using a custom-sized FoodSaver Bag, check the seal of the bag.
3
There may be a wrinkle in the bag along the seal, which causes
leakage and prevents air from being removed. Cut the bag and
reseal the edge.
Do not attempt to make your own side seams for a FoodSaver
4
Bag. They are manufactured with special side seams, which are
sealed all the way to the outer edge. Making your own side seams
may leave air pockets, which will cause leakage and prevent air
from being completely removed.
35