Attaching To The Camera/Removing From The Camera - Olympus MACRO FLASH SYSTEM Instructions Manual

<Attaching to the camera/Removing from the camera>
Confirm that both the camera and Macro Flash Controller are off.
Attaching or removing the Macro Flash Controller while either it or the camera is on may result in
malfunction.
Attach the RF-11 Ring Flash or TF-22 Twin Flash to the Macro Flash Controller.
• How to use the RF-11 Ring Flash : See page 15.
• How to use the TF-22 Twin Flash : See page 27.
How to attach
1.
Place the head section in the standard position (horizon-
tal, front).
2.
Remove the hot shoe cover from the camera.
• Store the hot shoe cover in the pocket of the macro flash
case to avoid losing it.
3.
Loosen the lock ring.
• If the lock pin is in the out position, put it to the in position by
turning it all the way in the opposite direction to [ LOCK]
until it stops.
• Do not apply excessive force to the lock pin.
• Do not touch the electric contact with a finger or metallic object.
• Do not attach the Macro Flash Controller while the lock pin is in the out
position. Otherwise, malfunction may result.
4.
Slide the Macro Flash Controller all the way into the hot
shoe until it clicks and stops.
5.
Turn the lock ring all the way in the direction of [ LOCK]
until it stops.
How to remove
1.
Loosen the lock ring, then slide the Macro Flash Control-
ler out of the hot shoe.
2.
Attach the hot shoe cover to the camera.
Lock pin
Electric contact