Packet Data Settings - Nokia N82 User Manual

encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network
supports them.
To enter the settings for the selected security mode,
select WLAN security settings.
Security settings for WEP
WEP key in use — Select the wired equivalent
●
privacy (WEP) key number. You can create up to
four WEP keys. The same settings must be
entered on the WLAN access point device.
Authentication type
●
Shared for the authentication type between
your device and the WLAN access point device.
WEP key settings — Enter
●
(length of the key), WEP key format (ASCII
Hexadecimal), and WEP key
in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of
●
authentication: EAP to use an extensible
authentication protocol (EAP) plug-in, or
shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key — Enter a password. The
●
same password must be entered on the WLAN
access point device.
— Select Open or
WEP encryption
or
(the WEP key data
Pre-
— Enter the settings as
WPA2 only mode — Only WPA2 enabled devices
●
are allowed to establish a connection in this
mode.
Advanced WLAN settings
Select Options Advanced settings
>
following:
IPv4 settings — Enter the IP address of your
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
service provider for these addresses.
IPv6 settings — Define the type of DNS address.
●
Ad-hoc channel (only for Ad-hoc) — To enter a
●
channel number (1-11) manually, select
defined.
Proxy server address
●
the proxy server.
Proxy port number
●
number.

Packet data settings

Press , and select Tools
Connection Packet data.
>
The packet data settings affect all access points
using a packet data connection.
Packet data connection
●
available and you are in a network that supports
packet data, the device registers to the packet
and from the
User
— Enter the address for
— Enter the proxy port
Settings
> >
— If you select When
157