After Recording A Video; Camera Settings - Nokia N82 User Manual

within a minute. Select
recording.
To zoom in or out of the subject, use the zoom
key in your device.
4. To stop recording, select Stop. The video clip is
automatically saved to the
folder of Gallery. The maximum length of the
video clip depends on the available memory.
To activate the front camera, select
secondary camera. To start recording a video,
press the scroll key. To zoom in or out, scroll up or
down.

After recording a video

After you record a video clip, select the following
from the active toolbar (available only if
captured video is set to
To immediately play the video clip you just
●
recorded, select Play
If you do not want to keep the video, select
●
Delete ( ).
To send the video clip using a multimedia
●
message, e-mail, or other connection methods,
such as Bluetooth connectivity, press the call key,
or select Send ( ). See "Write and send
messages", p. 109. See "Send data using
Bluetooth connectivity", p. 80.
Continue to resume
Images & videos
Options Use
>
Show
On in the video settings):
( ).
This option is
not available during an active call. You may not
be able to send video clips saved in the .mp4 file
format in a multimedia message.
You can also send the video clip to a call recipient
during an active call. Select
(only available during an active call).
To upload the video clip to a compatible online
●
album, select (only available if you have set up
an account for a compatible online album).
"Share images and videos online", p. 52.
To return to the viewfinder to record a new video
●
clip, press the capture key.

Camera settings

There are two kinds of settings for the camera:
setup settings and main settings. The setup settings
return to the default settings after you close the
camera, but the main settings remain the same
until you change them again. To adjust the setup
settings, use the options in the active toolbar.
"Setup settings—adjust colour and
lighting", p. 42. To change the main settings, in
the image or video mode, select
Settings.
Send to caller ( )
See
See
Options
>
41