Setting The Pjlink™ Certifi Cation (Pjlink Certifi Cation Mode); Save And Exit - Mitsubishi Electric XL1550U Network Manual

Preparation/SetUp (continued)
Setting the PJLink™ certifi cation (PJLink certifi cation Mode)
Enter "5" and press the Enter key.
1
When you don't use PJLink™ protocol
•
communication, skip this item. (See page 16 for
PJLink™.)
To enable the PJLink™ certifi cation, enter "1" and
2
press the Enter key. To disable it, enter "0" and press
the Enter key. (Default is ON (1).)

Save and exit

Enter "9" and press the Enter key.
1
2 The setting screen is shaded and the setting is updated.
• It takes about 10 seconds for the setting to be
updated. Don't perform communication during this
period.
• Because the password, display language, LAN control, and PJLink
you can also set them on the command prompt window of the personal computer. Enter the following command and
press the Enter key.
> telnet [IP address you set] 9999
When setting menu appears, perform the setting procedure as described above.
(Note)
Check that the port number "9999" isn't blocked by the fi rewall.
™ certifi cation are set using the telnet function,
[">" shows a prompt.]
EN-11