Setting The Password (Password Setup) - Mitsubishi Electric XL1550U Network Manual

Preparation/SetUp (continued)

Setting the password (Password Setup)

Enter "0" and press the Enter key.
1
Input the old (current) password and press the Enter
2
key. (Default password is admin.)
If you input a wrong password, an error message
•
appears and the setting menu is displayed again.
In this case, set the password again.
• If you forget your password, select "7 factory
defaults," input the password "projectorcontroller,"
and then select "9 save and exit" to perform
initialization.
Input a new password (example: "proj2000") and
3
press the Enter key.
(Note)
Use single-byte alphanumeric characters only.
4 Input the new password (example: "proj2000") again
and press the Enter key.
If you input a wrong password, an error message
•
appears and the setting menu is displayed again.
In this case, set the password again.
EN-9