Burner - Miele CS 1011 Operating And Installation Instructions

Cleaning and care

Burner

Do not clean any parts of the burner
in a dishwasher.
The burners should be dismantled and
then cleaned by hand using a solution
of warm water and a little washing-up
liquid applied with a soft sponge.
Parts of the burner that cannot be
removed should be wiped clean with a
damp cloth only.
The ignitors and ignition safety devices
should be very carefully wiped clean
using a well wrung out cloth.
Do not let the ignitor get wet. If it gets
wet it will not spark.
After cleaning, dry all surfaces with a
clean cloth.
Make sure that the flame slits are clean
and completely dry.
The surfaces of the two burner caps
will become more matt with time. This
is quite normal and will not affect the
operation of the hob.
32
To reassemble the burner
After cleaning the burner, it must be
reassembled in the correct order.
^ Place burner head j on to burner
base m so that the ignition safety
device k and the ignitor l extend
through their respective holes in the
burner head.
The notch on the burner cap
sit in the groove
head.
The notch on the burner head
must sit in the groove
base.
^ Place burner ring i in position.
^ The place burner cap g and h in
position.
must
of the burner
of the burner