Miele T 4362 Operating Instructions Manual page 25

Problem
The drying
process goes on
too long or even
switches off.
Possible cause
Important: Before attempting to remedy one of the following
causes, switch the dryer off and switch on again to start the
programme again.
Ventilation to the dryer is
insufficient (e.g because it is
installed in a room which is
too small).
The fluff filter may be
blocked.
The laundry has not been
spun sufficiently.
The tumble dryer has been
overloaded.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in the
laundry.
The vent ducting or the
ventilation outlet is blocked;
Problem solving guide
Remedy
Open a door or window while
the machine is in operation
for increased air flow.
Remove any fluff.
Make sure that your laundry
is thoroughly spun at highest
spin speed for the type of
fabric.
Do not exceed the maximum
load for the programme
selected.
– Open zips next time.
If the problem occurs again,
dry garments with long zips
using "Timed drying - Warm
air".
– Check all parts of the
extraction system on a
regular basis (e.g. wall
vent, external grille, bends
in the ducting etc.) and
make sure they are all free
of any hindrance.
– Remove any fluff.
25