Electrical Connection - Miele H 4880 BP Pyrolytic Operating And Installation Manual

All electrical work should be
undertaken by a suitably qualified
and competent person in strict
accordance with current national
and local safety regulations
(BS 7671 in the UK).
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure power is not supplied to the
appliance until after installation or
repair work has been carried out.
The voltage and connected load are
given on the data plate, visible with the
oven door open. Ensure that these
match the household mains supply.
Please quote these data, and the model
and serial number when contacting the
Miele Service dept.
Connection of this appliance should be
made via a suitable isolator, which
complies with national and local safety
regulations, and the on/off switch
should be easily accessible after the
appliance has been built in.
If the switch is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a residual current device with a trip
current of 30 mA (in accordance with
DIN VDE 0664, VDE 0100 Section 739).
When switched off there must be an
all-pole contact gap of 3 mm in the
isolator switch (including switch, fuses
and relays acc. to EN 60 335).

Electrical connection

This device is intended for the
connection to a power supply system
with a maximum permissible system
impedance Z
MAX
interface point (power service box) of
the user's supply.
The user has to ensure that this device
is connected only to a power supply
system which fulfillls the requirement
above. If necessary, the user can ask
the public power supply company for
the system impedance at the interface
point.
Important U.K.
This appliance is supplied with a 3-core
cable for connection to a single phase
230 V 50 Hz supply.
The wires are coloured in accordance
with the following code:
Green/yellow = earth
Blue = neutral
Brown = live
In other countries check these details
with your supplier.
WARNING
THIS APPLIANCE MUST BE
EARTHED.
Position of the data plate
of 0.42 Ohm at the
63