Calibrating The Load Size Sensor To Zero - Miele WT 2679 WPM Operating Instructions Manual

Before using for the first time
Reminder to remove transport struts
To avoid the risk of damage, the
transport struts must be removed
before the washer-dryer is used for
the first time. See "Installation and
connection" for instructions on how
to do this.
Remove transport
i
struts
OK
^ After removing the transport struts (if
this has not already been done by
your fitter) press the OK button.
Running your first programme
Your washer-dryer is now ready for the
first programme to be run.
15:00
Select programme
^ Turn the programme selector to the
Cottons position.
^ Press the Start/Stop button.
^ When the programme has finished,
turn the programme selector to Stop
and switch off the washer-dryer.
The load sensor must then be
calibrated to zero as you would with
bathroom scales.
14
Calibrating the load size sensor to
zero
^ Switch the machine on.
^ Open the drum door.
^ Turn the programme selector to the
Cottons position.
^ Press and hold the Load/Detergent
button pressed in until the following
message appears in the display:
Zero setting
i
OK
^ Turn the programme selector to Stop
and switch off the washer-dryer.
The machine is now ready for use.