Calibrating The Load Size Sensor To Zero - Miele WT 2679 i WPM Operating Instructions Manual

Reminder to remove transport struts
To avoid the risk of damage, the
transport struts must be removed
before the washer-dryer is used for
the first time. See "Installation and
connection" for instructions on how
to do this.
Remove transport
i
struts
OK
^ After removing the transport struts (if
this has not already been done by
your fitter) press the OK button.
Running your first programme
Your washer-dryer is now ready for the
first programme to be run.
15:00
Select programme
^ Turn the programme selector to the
Cottons position.
^ Press the Start/Stop button.
^ When the programme has finished,
turn the programme selector to Stop
and switch off the washer-dryer.
The load sensor must then be
calibrated to zero as you would with
bathroom scales.
Before using for the first time
Calibrating the load size sensor to
zero
^ Switch the machine on.
^ Open the drum door.
^ Turn the programme selector to the
Cottons position.
^ Press and hold the Load/Detergent
button pressed in until the following
message appears in the display:
Zero setting
i
OK
^ Turn the programme selector to Stop
and switch off the washer-dryer.
The machine is now ready for use.
13