Advertisement
All electrical work should be carried
out by a suitably qualified and com-
petent person, in strict accordance
with national and local safety regula-
tions.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can-
not be held responsible for un-
authorised work.
Ensure power is not supplied to the
appliance while installation work is
being carried out.
The appliance must only be oper-
ated when built-in. This is to ensure
that all electrical parts are shielded.
Live parts must not be exposed.
The voltage,rated load and fusing are
given on the data plate. Ensure that
these match the household mains sup-
ply.
Connection should be made via a suit-
able isolator which complies with na-
tional and local safety regulations, and
the On/Off switch should be easily ac-
cessible after the appliance has been
built in.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA (in accordance
with DIN VDE 0664, VDE 0100 Section
739).
When switched off there must be an
all-pole gap of at least 3 mm in the iso-
lator switch (including switch, fuses and
relays according to EN 60 335).
The appliance is supplied for connec-
tion to an a.c. single phase 230-240 V,
50 Hz supply with a 3-core cable.
The wires in the mains lead are col-
oured in accordance with the following
code:
Green/yellow = earth
Blue
= neutral
Brown
= live
The electrical safety of this appliance
can only be guaranteed when continu-
ity is complete between the appliance
and an effective earthing system, which
complies with local and national regula-
tions. It is most important that this basic
safety requirement is tested by a quali-
fied electrician. The manufacturer can-
not be held responsible for the conse-
quences of an inadequate earthing
system such as an electric shock.
The manufacturer can assume no re-
sponsibility for damage which is the di-
rect or indirect result of incorrect instal-
lation or connection.
25
Hide quick links:
Advertisement
