Configuring The Control Unit Or Receiver; Configuration Wizard - Meridian G series Installation Manual

Configuring the control unit or receiver

This chapter explains how to configure the control unit or receiver using the Configuration
Alternatively, for complete control over all aspects of the product's configuration you can set
up the unit from a computer using the Meridian Configuration Program. For full information
refer to the Meridian Configuration Program Guide available separately.

Configuration Wizard

The Configuration Wizard leads you through the correct
sequence to configure your control unit or receiver. Alternatively,
you can skip between the configuration stages, which allow you to
reset the configuration, or configure the sources or other settings
of the control unit or receiver.
To run the Configuration Wizard
• If necessary press On/Off to put the control unit or receiver into
standby.
• Press More.
If the product is locked the display shows:
Version
• Press Unlock to unlock it, then press More.
Wizard.
The displays then shows:
• Press Wizard.
Follow the sequence of configuration stages described in the
following pages, pressing Next to proceed after completing each
stage.
To go back to an earlier configuration option
• Press Back.
To return to the title screen for each stage
• Press Home.
Unlock
To exit from the Configuration menus
• Press On/Off.
Wizard
Version Lock
1 7
C o n f i g u r i n g t h e
c o n t r o l u n i t o r
r e c e i v e r