Configuring the control unit or receiver
This chapter explains how to configure the control unit or receiver using the Configuration
Alternatively, for complete control over all aspects of the product's configuration you can set
up the unit from a computer using the Meridian Configuration Program. For full information
refer to the Meridian Configuration Program Guide available separately.
Configuration Wizard
The Configuration Wizard leads you through the correct
sequence to configure your control unit or receiver. Alternatively,
you can skip between the configuration stages, which allow you to
reset the configuration, or configure the sources or other settings
of the control unit or receiver.
To run the Configuration Wizard
• If necessary press On/Off to put the control unit or receiver into
standby.
• Press More.
If the product is locked the display shows:
Version
• Press Unlock to unlock it, then press More.
Wizard.
The displays then shows:
• Press Wizard.
Follow the sequence of configuration stages described in the
following pages, pressing Next to proceed after completing each
stage.
At any stage in the Configuration Wizard the following options are
available:
To do this
Go back to an earlier configuration option
Unlock
Return to the title screen for the stage
Exit from the configuration menus
Display help about the current option
Version
Wizard
Lock
Press
Back
Home
On/Off
More
1 7
C o n f i g u r i n g t h e
c o n t r o l u n i t o r
r e c e i v e r