Flymo Cordless Multi-Trim MCT250 Instruction Manual page 8

1. Attach steady handle to product using bolt
and handle knob as shown in Fig I.
2. Adjust the steady handle to a comfortable
operating position, see Fig J., by
unscrewing the handle knob, springing the
side lugs apart, moving the handle to the
required position, carefully re-engaging the
teeth and then tightening the handle knob.
See Fig K.
How the automatic line feed works (L)
1. A short length of new line is fed out every
time you switch on, this is caused by the
cutting head accelerating up to its full
speed.
2. To feed more line, it is necessary to switch-
off, allow the motor to stop and then restart.
When edging do this frequently.
3. When the line feeds you will hear a change
in the motor sound as well as the noise
generated by the line being cut to its length.
4. If the line does not feed see Fault Finding
Hints for further information.
Handle Adjustment
I
handle
knob
J
Auto Line Feed System
L
7
bolt
K
line cutter